Hi there, wondering what mesh count is best for printing with Permaset Aqua. On a forum someone had recommended 110 (43T) because higher counts would clog. However, it was then recommended to me to go as high as 290 to get the detail I want for my designs. I will be printing 2 colors (red and black) on cotton tees. I’d appreciate any feedback. Thanks
Permatone - 43T to 120 T
Supercover - 32T to 64T - higher mesh tend to dry fast (90T) so not recommanded in my opinion.
You can have lot of details with a 43T, just with the right equipment and the right techniques.
What about with Permaset Aqua Standard (that’s what I have)?
Perhaps it’s newer than the 2015 posts, but I have used 160 mesh with the Permaset retarder and no clogging/drying on the screen. trying 230 mesh soon.